Support Forums
Restart the device via Command Line Interface

Hi there,

For some reason, I can connect to the DT85 via dEX-2 but the SCADA can communicate with the dEX-2. Since both the devices are onsite, can someone please tell me if there is a way to restart (like power cycle) the DT85 via Command Line Interface using a command?

Thanks.

Hi there, For some reason, I can connect to the DT85 via dEX-2 but the SCADA can communicate with the dEX-2. Since both the devices are onsite, can someone please tell me if there is a way to restart (like power cycle) the DT85 via Command Line Interface using a command? Thanks.

Hi ajrai,

You can send HRESET command from the command interface; it is similar to a power cycle.

Best regards,
Rudy Gunawan

Hi ajrai, You can send HRESET command from the command interface; it is similar to a power cycle. Best regards, Rudy Gunawan
25
1
2
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft