Support Forums
CanGate

I am wanting to connect a CanGate to a DT80 series 2 and the literature I have read still points me to using DeLogger instead of Dex2. Does anyone know if you can still use the CanGate and Dex2? Its for a stationary engine to monitor engine output and pump rate.
Is anyone using this combination?

Thanks.

I am wanting to connect a CanGate to a DT80 series 2 and the literature I have read still points me to using DeLogger instead of Dex2. Does anyone know if you can still use the CanGate and Dex2? Its for a stationary engine to monitor engine output and pump rate. Is anyone using this combination? Thanks.

Hi C.Jackson,

You can still use dEX 2.0 to write a program for CANGate, however the syntax must be declared in a manual channel since there is no template available yet for controlling serial channel.

Best regards,
Rudy Gunawan

Hi C.Jackson, You can still use dEX 2.0 to write a program for CANGate, however the syntax must be declared in a manual channel since there is no template available yet for controlling serial channel. Best regards, Rudy Gunawan
34
1
2
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft