General Discussions
Torque sensor connection

Hello,
I hope you are well.
I have a DT85 series 4 datalogger and I want to measure the torque + rotation speed + power from my torque sensor, which has a 12 pin connector (picture attached). I have also attached the manual for the torque meter (DRBK from applied measurements). I have also attached the datalogger manual.
Any help would be greatly appreciated.
Thanks!6446c6d23a5f9
6446c6d2628b2

Hello, I hope you are well. I have a DT85 series 4 datalogger and I want to measure the torque + rotation speed + power from my torque sensor, which has a 12 pin connector (picture attached). I have also attached the manual for the torque meter (DRBK from applied measurements). I have also attached the datalogger manual. Any help would be greatly appreciated. Thanks!![6446c6d23a5f9](serve/attachment&path=6446c6d23a5f9) ![6446c6d2628b2](serve/attachment&path=6446c6d2628b2)

Hi Salman,

In addition to our previous reply, page 14 of the screenshot indicate the scaling after you read the sensor's signal (voltage has a range of -5V...+5V, the current has a range of -2mA...18mA).

Best regards,
dataTaker Expert

Hi Salman, In addition to our previous reply, page 14 of the screenshot indicate the scaling after you read the sensor's signal (voltage has a range of -5V...+5V, the current has a range of -2mA...18mA). Best regards, dataTaker Expert
19
1
2
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft