Hi

We have a DT51 we dusted off. The problem I have is that when you startup the logger there are some default scans, spans and switch settings, if I delete the scans and write new scan, when I restart the logger or cycle the power, the logger defaults back to the "built-in" scan and switches.

Is there a setting or switch where i can stop this from happening?

Thanks,
Paul

Hi PaulH,

When the memory card is not present or not detected, the program will reside in the temporary processor's memory which will get wiped on the power cycle. The best action is to save the program to the memory card.

Best regards,
dataTaker Expert