Legacy Hardware and Apps
Real time data view at hyperterminal

Is there any possibility to get the real time scan data in the hyper terminal? If possible then please let me know the procedure.

Regards,
Pradipta

Is there any possibility to get the real time scan data in the hyper terminal? If possible then please let me know the procedure. Regards, Pradipta

Good morning Pradipta,

When you connect send /E/M/R, when you disconnect send /e/m/r

Cheers,
Roger

Good morning Pradipta, When you connect send /E/M/R, when you disconnect send /e/m/r Cheers, Roger

Thank you very much.

This is working fine. I would like to inform you that if I send the program to the logger as "send program and save as reset job " then it executes the program send the data string to the terminal after sending /E/M/R command.

But if I turn it off and turn it on again, it starts executing the residing prog. From my hyper terminal after sending the /E/M/R command, logger simply send the parameter (sensor data - Eg.Temp 23 Deg C) without date and time stamp .

Need your suggestion to sort out the problem .

Regards
Pradipta

Thank you very much. This is working fine. I would like to inform you that if I send the program to the logger as "send program and save as reset job " then it executes the program send the data string to the terminal after sending /E/M/R command. But if I turn it off and turn it on again, it starts executing the residing prog. From my hyper terminal after sending the /E/M/R command, logger simply send the parameter (sensor data - Eg.Temp 23 Deg C) without date and time stamp . Need your suggestion to sort out the problem . Regards Pradipta

Good morning Pradipta,

Change your program and add /T /D
/T will turn on the Time stamp
/D will turn on the Date stamp

Please read up on the Switches. Page 111 of the DT800 Users manual.

Cheers,
Roger

Good morning Pradipta, Change your program and add /T /D /T will turn on the Time stamp /D will turn on the Date stamp Please read up on the Switches. Page 111 of the DT800 Users manual. Cheers, Roger
43
4
2
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft