Legacy Hardware and Apps
4 wire Carlson sensor on DeLogger

I have a DT80-2 series and DeLogger5V1R5 software, but I can not configure option "n+R(II)" to read (R1+R2+Rc) with a 4-wire Carlson sensor configuration (figure 83, page 202 of DT80 User's Manual UM-0085-A7).

Thanks

I have a DT80-2 series and DeLogger5V1R5 software, but I can not configure option "n+R(II)" to read (R1+R2+Rc) with a 4-wire Carlson sensor configuration (figure 83, page 202 of DT80 User's Manual UM-0085-A7). Thanks

Good morning Manuel Gomes,

You will need to use the manual channel type to enter the dataTaker code directly.

Cheers
Roger

Good morning Manuel Gomes, You will need to use the manual channel type to enter the dataTaker code directly. Cheers Roger
11
1
2
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft