General Discussions
internal temp

Hello,
I am using a DT82E and I was wondering if there was a way to display/report the loggers internal temperature or tell what it is using as a cold junction compensation temperature for thermocouples. I am looking at the mV output and it must be compensating for the cold junction temperature, but I cannot tell where or how.

Hello, I am using a DT82E and I was wondering if there was a way to display/report the loggers internal temperature or tell what it is using as a cold junction compensation temperature for thermocouples. I am looking at the mV output and it must be compensating for the cold junction temperature, but I cannot tell where or how.

Hi Rheniumjoe,

You can use internal temperature channel REFT to get cold junction temperature. That channel reflects the temperature of copper track near the terminal behind analog terminal 2 which indirectly reflect junction temperature.

Best regards,
Rudy Gunawan

Hi Rheniumjoe, You can use internal temperature channel REFT to get cold junction temperature. That channel reflects the temperature of copper track near the terminal behind analog terminal 2 which indirectly reflect junction temperature. Best regards, Rudy Gunawan
29
2
2
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft