Using Hub with DataTaker

Gerion10

posted Apr 8 '19 at 8:11 am

Hi guys,

I'm using i-checker devices like these:
http://www.aros-solar.com/es/sistemas-de-monitorizacion/ichecker/

These measure the current passing through a conductor but I need a device that takes the data stream.

Could I connect to Datataker Mider and the current through streamings?
Or if there is any other option to measure the current of the i-checker with Datataker DT 800.

Hi guys, I'm using i-checker devices like these: http://www.aros-solar.com/es/sistemas-de-monitorizacion/ichecker/ These measure the current passing through a conductor but I need a device that takes the data stream. Could I connect to Datataker Mider and the current through streamings? Or if there is any other option to measure the current of the i-checker with Datataker DT 800.

dataTaker Expert

posted Apr 8 '19 at 8:22 am

Hi Gerion,

It should not be a problem feeding all RS485 data through S-Hub unit. Then DT800 can read them separately based on S-Hub address.
However I am not sure whether this method will stream the data, it looks like you may need to poll each sensor at regular interval.

Best regards,
Rudy Gunawan

Hi Gerion, It should not be a problem feeding all RS485 data through S-Hub unit. Then DT800 can read them separately based on S-Hub address. However I am not sure whether this method will stream the data, it looks like you may need to poll each sensor at regular interval. Best regards, Rudy Gunawan

Pending draft

Selected posts

Confirm move posts

Insufficient permissions

Select a different topic

Confirm selection

Edit history