Hi all,

First Question,

I would like to ask if there is a manual I could down load based on the program builder and not on text file programing. Converting what the text line is in the manual to the program builder is a bit tricky!!

Ok next question,
I have a pressure transducer sending back a voltage signal to my DT800, the span in set for the transducer output to be read in PSI on a mimic. How would I convert this read out from PSI to °C.? I have the polynomial for the gas I am using which is R134a in a refrigerator.
I then want to compare this new temperature value with a temperature from a K type sensor and display the difference.

I hope I’m comprehensible and all help will be gratefully received.
James.

Hi James,

There is no DeLogger manual in pdf, all instruction is available as help file that you can access through DeLogger software.

Conversion PSI to °C can be done through span setting.
You can create a span setting through scaling tab.
Then applied that span setting into your channel, please check the attachment.

Best regards,
Rudy Gunawan

Hi Rudy,

Thanks for the complete instructions, this really helps.
I will try the help file as well.

Thanks,
James.