Is it possible to log 65,000 data sample in burst mode at 100 kHz? If yes what are the configurations to be set by the user?

If not what is the maximum burst frequency at which I can log 65000 data sample? Is it possible to repeat burst session continuously without any time gap ?

Please answer urgently.

Good morning gpradipta,

The total number of readings depends on the channel type being sample. You will have to know exactly what type of channels and how many before before you can calculate the maximum number of samples and the maximum sample speed.

The burst mode is intended to take a snap shot of an event. It is not possible to sample continuously at the specified speed. When in burst mode all the CPU processing time is taken looking for triggers etc. Once the burst is captured the logger then needs to calculate the values and store them to memory.

Cheers,
Roger

Dear Roger,

Thank you very much for your prompt reply. I was very anxious about this. I'll go through the note you have mentioned and will let you know the findings.

For your information we have acquire data in burst mode from two quarter bridge strain gauges.

Thanks and regards,
Pradipta