Is there any possibility to get the real time scan data in the hyper terminal? If possible then please let me know the procedure.

Regards,
Pradipta

Good morning Pradipta,

When you connect send /E/M/R, when you disconnect send /e/m/r

Cheers,
Roger

Thank you very much.

This is working fine. I would like to inform you that if I send the program to the logger as "send program and save as reset job " then it executes the program send the data string to the terminal after sending /E/M/R command.

But if I turn it off and turn it on again, it starts executing the residing prog. From my hyper terminal after sending the /E/M/R command, logger simply send the parameter (sensor data - Eg.Temp 23 Deg C) without date and time stamp .

Need your suggestion to sort out the problem .

Regards
Pradipta

Good morning Pradipta,

Change your program and add /T /D
/T will turn on the Time stamp
/D will turn on the Date stamp

Please read up on the Switches. Page 111 of the DT800 Users manual.

Cheers,
Roger

Thank you very much

Best Regards
Pradipta