Hello Everybody,

I have a sensor which is porduced by Monitor sensor. You can see at link: http://monitorsensors.com/upload/PDF/AN.pdf
With this sensor is: 3 wire

• Red: supply power 6-28V -White: common -Black: data I use external power 12V to "RED" Channel 2 analog: +/-

My code:
BEGIN
S1=0.1,40,2,10
RA1M LOGONA
2F(S1)
END

or

BEGIN
S1=0.1,40,0,2500
RA1M LOGONA
2V(S1)
END
....

I don't know why the result is wrong. The program is problem, isn't it?

Please give me some advice

Thank you very much

Best regards,
thuyvan

Hi thuyvan,

What is the sensor order codes? Is it AN2-V2 or AN2-F?
Could you explain about the wrong result?

Best regards,
Rudy Gunawan

Hello Rudy,

I have just asked the customer again. They said the sensor is Output: Monibus serial data ASCII format.
I am so sorry for my mistake when i have the information of sensor is Output: 0-1Volt before
I have never connected sensor to DataTaker by Monibus serial data Ascii format. it is difficult to connect
Ok. i will try to connect it.
Thank you Rudy

thuyvan

Hi thuyvan,

Please try to capture the output string (Monibus) via any command terminal (i.e.: hyperterminal).
Then send me some sample of that string, I may be able to help you creating parsing program.

Best regards,
Rudy Gunawan