MAINTAIN_VARS=YES is not working on power loss

smaurer

posted Apr 13 '19 at 4:19 pm

Product: DT82E-3
Serial Number: 103900
dataTaker 82 Version 9.16.5728 Flash 2014/10/03 17:46:55
VLITH (3.6V) 3.63 V PASS

I have assumed that the CVs would be restored after power is connected. Is my assumption correct?

I have been testing the MAINTAIN_VARS=YES functionality and it works great when I use HRESET command, but not when I disconnect power. The CVs are not being restored when the power is connected. The Datataker is new and the details are below. Product: DT82E-3 Serial Number: 103900 dataTaker 82 Version 9.16.5728 Flash 2014/10/03 17:46:55 VLITH (3.6V) 3.63 V PASS I have assumed that the CVs would be restored after power is connected. Is my assumption correct?

Roger

posted Apr 13 '19 at 4:22 pm

Hi Smaurer

The only reason for the maintain vars to fail is when the variables have been initialized to zero at the start if the program. Could you please post you code for review?

Cheers

Roger

Hi Smaurer The only reason for the maintain vars to fail is when the variables have been initialized to zero at the start if the program. Could you please post you code for review? Cheers Roger

dataTaker Expert

posted Apr 13 '19 at 4:23 pm

Hi Smaurer,

Unfortunately that issue is confirmed.
I will contact you directly about this issue.

Best regards,
Rudy Gunawan

Hi Smaurer, Unfortunately that issue is confirmed. I will contact you directly about this issue. Best regards, Rudy Gunawan

Pending draft

Selected posts

Confirm move posts

Insufficient permissions

Select a different topic

Confirm selection

Edit history