Hello!

I have got a problem regarding the modem power config. I have fully configured a DT80M (system name, time and so on) including the modem power config, which is set to "ALWAYS ON" due the need of the DT to act as a http server. If I make a HARDRESET or a power loss occurs, the system reloads the config correctly, all parameters are set as its config value except the modem power config, which it is set to "ONLY WHEN REQUIRED" (Factory setting).

So, if a power loss occurs and the DT retries, the modem wont be active thus I won't be able to access the DT from internet. Anyone could tell me if this is a Firmware bug? Maybe am I doing something wrong? I have also thought adding the command "PROFILE MODEM_SESSION TIMING_CONTROL=ALWAYS" to the current job as a workaround, but I have not tried it yet. Any thoughts? Thanks in advance.

Hi

I was able to reproduce the same issue on my Logger, I have reported the issue to our Firmware Engineer.

But strangely this an intermittent and does not happen all the times , Most of the times the settings are retained , But on couple of occasions the Timing_Control setting changed back to default.

Thanks
Regards
Lokesh