G'Day,

I just performed a 'hard reset' on my DT80s2 over an hour ago & now my sensors that require power (via the 12v port) are not working.

I have checked the power status via the '1SSPWR' command & all is good. I have also physically tested the port with a volt meter & got a reading of 11.93V which also seems correct.

I even just tried swapping the green ports over but still no change

What should I try next?

Thanks,
Grant

Okay, all sorted, was a simple code error from me. I simply had the spans & serial code for my sensors outside my program code, thus when the 'RUNJOBONRESET' code kicked in these settings were simply not run.

This has now been changed & all is again running correctly