Hi,

currently put my dt80 at site, and some sites is hard to reach by telco. i'm using dt80 + digi connect wan 3g or dt80M...

sometimes, its hard to get connected or status check failed for using delogger or dt-usb (dexview)

so i'm using hyper terminal if that happen.

can you list down some important commands for hyper terminal that can works with datataker.

etc: stop data, unload, clear session, start data and all the simple one... tqvm

Good morning MrHim,

You would be better off using DeTransfer.
It is our own terminal program and it is configured to talk with our products.
DeTransfer can be down loaded from
http://www.thermofisher.com.au/Uploads/file/Environmental-Industrial/Process-Monitoring-Industrial-Instruments/Industrial-Loggers/Firmware/DeTransfer3.27.zip

You can use hyper terminal. When you first connect you need to send /E/M/R <Cr>
/E = Turn on Echo
/M = Turn on Messages
/R = Turn on real time data return.

When you disconnect you must send /e/m/r<Cr>
All commands are listed in the manual and when you are connected you can type in Help to see a list of help files and Help Topic to show the help file the items available.

e.g. Help Commands will display a list of the DT80 commands and their syntax.

Cheers,
Roger