Support Forums
DT80 Boot loader stuck in loop

A failed attempt at up grading to version 9 firmware has resulted in the DT80 being stuck in a loop.

The bootloader fails with an error of L6 ( not always ). The bootloader then starts over again. The DT80 will not read the files from the memory stick.

Is there a way of breaking the cycle? How can the memory be re-flashed when the com's have not been configured?

A failed attempt at up grading to version 9 firmware has resulted in the DT80 being stuck in a loop. The bootloader fails with an error of L6 ( not always ). The bootloader then starts over again. The DT80 will not read the files from the memory stick. Is there a way of breaking the cycle? How can the memory be re-flashed when the com's have not been configured?

Good morning Steve,

I have received your emails and will be responding to then today.
I know you are using the USB method to upgrade. What happens when you remove the USB memory device does the boot loader time out and revert back to the old firmware?

Can you also check the "Edit" key is not stuck in the down position? If the edit key is held down when the power is turned on then the DT80 will start up in boot mode.

Cheers,
Roger

Good morning Steve, I have received your emails and will be responding to then today. I know you are using the USB method to upgrade. What happens when you remove the USB memory device does the boot loader time out and revert back to the old firmware? Can you also check the "Edit" key is not stuck in the down position? If the edit key is held down when the power is turned on then the DT80 will start up in boot mode. Cheers, Roger
16
1
2
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft