Support Forums
"communication with the logger unsuccessful"

I have taken over a DT85 programmed by someone else. I have connected to the DT85. I need to change some IP addresses as a new router has been installed.

5cb7b1a9c4537

I can't open the command box to change IP addresses.
I am steep on the learning curve here!
I get the message on the attachment.
I have opened port 843, still no joy.

Any ideas?

I have taken over a DT85 programmed by someone else. I have connected to the DT85. I need to change some IP addresses as a new router has been installed. ![5cb7b1a9c4537](serve/attachment&path=5cb7b1a9c4537) I can't open the command box to change IP addresses. I am steep on the learning curve here! I get the message on the attachment. I have opened port 843, still no joy. Any ideas?

Hi wldlkdata,

That usually port 7700 was being blocked.

If you are using USB cable then a background program is using port 80 in your PC.
DTUsb will make a new arrangement to port 81 as well as swapping other port by 1 (including port 7700 into port 7701).

If you are using Ethernet connection, please check any blockage/ firewall setting on port 7700.

Best regards,
Rudy Gunawan

Hi wldlkdata, That usually port 7700 was being blocked. If you are using USB cable then a background program is using port 80 in your PC. DTUsb will make a new arrangement to port 81 as well as swapping other port by 1 (including port 7700 into port 7701). If you are using Ethernet connection, please check any blockage/ firewall setting on port 7700. Best regards, Rudy Gunawan
16
1
2
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft