Support Forums
How to configure DT85G

I have to configure DT85G to measure Voltage in mili volt in one channel and current in micro ampere in second channel every second .

Please help me.

I have to configure DT85G to measure Voltage in mili volt in one channel and current in micro ampere in second channel every second . Please help me.

Hi Yogi,

When you started dEX web interface, and go to "Configure the Logger" you will see one schedule (Schedule_1 (A)) has been pre-configured to run every 5 seconds.
Please change this interval into 1 second according to your requirement.

Then we can add some channels as a member of schedule A.
While the highlight cursor in schedule A:

  • Click Add followed by Measurement then Voltage to add voltage channel.
  • Do the same but with Current to add current channel.

After this process you already create one voltage channel and one current channel.

You can then send the program to dataTaker by clicking File followed by Save to Logger.

Best regards,
Rudy Gunawan

Hi Yogi, When you started dEX web interface, and go to "Configure the Logger" you will see one schedule (Schedule_1 (A)) has been pre-configured to run every 5 seconds. Please change this interval into 1 second according to your requirement. Then we can add some channels as a member of schedule A. While the highlight cursor in schedule A: - Click Add followed by Measurement then Voltage to add voltage channel. - Do the same but with Current to add current channel. After this process you already create one voltage channel and one current channel. You can then send the program to dataTaker by clicking File followed by Save to Logger. Best regards, Rudy Gunawan
26
1
2
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft