Hi,
I am using the +5V output to power a humidity sensor, I have used the command +5VSW=1 and set the logger up so that the 12V subsystem is continuously powered. However when I run the logger, the +5V works for short scan times (5secs) but for 15min scans the +5V does not switch on and so the sensor gives a bad reading.
Does whether having the USB connected affect whether the +5V SW is available, because it seems to work if the USB is left connected to a laptop.
Hi,
I am using the +5V output to power a humidity sensor, I have used the command +5VSW=1 and set the logger up so that the 12V subsystem is continuously powered. However when I run the logger, the +5V works for short scan times (5secs) but for 15min scans the +5V does not switch on and so the sensor gives a bad reading.
Does whether having the USB connected affect whether the +5V SW is available, because it seems to work if the USB is left connected to a laptop.