I have problem with my modem connection to DT85G.

I have got AT command modem and I am using below string codes as mentioned in DT85g manual which is wavecom supreme GSM modem;

AT&S0
AT&D2
ATS0=4
AT&C1
AT+IFC=2,2
AT+ICF=3,4
AT+IPR=57600
ATE0
AT&W

and I am using this code for DT85g

PROFILE "HOST_MODEM" "INIT"="AT"
PROFILE "HOST_MODEM" "SEND_BANNER_ON_CONNECT"="NO"

PROFILE "HOST_PORT" "BPS"="57600"
PROFILE "HOST_PORT" "FLOW"="HARDWARE"

and when you called modem had connection with line but DT85g not responding.

I used both connection programs hyperterminal and detransfer, both the same situation.
I would to know somebody had this type a problem.

Good morning tolgasirlan,

First make sure you have a fully pin out parallel cable between the DT8x and the modem.
Second connect and power up the modem then power up the DT8x. During the reset process the DT8x will check to see if a modem is connected and configure itself for the modem.

Cheers,
Roger