Hello All Readers
I would appreciate some guidance on how to set up dEX for the following measurement
Background: measuring the voltage from a wind turbine output which, is vague,....comes and goes at random according to the wind. Obviously, don't want to be sampling with the DT80 while the turbine is not outputting a voltage
Voltage input to DT80 is 0-10VDC
Would like to trigger a measurement when a voltage, greater than zero, appears at the input of the DT80 (channel 1), and then stop measuring when the voltage falls to zero again.
I am using the dEX utility to program the device, and am fine with setting up the channel definition......just no sure of the triggering setup for the above
Thanks and best regards
ray
Hello All Readers
I would appreciate some guidance on how to set up dEX for the following measurement
Background: measuring the voltage from a wind turbine output which, is vague,....comes and goes at random according to the wind. Obviously, don't want to be sampling with the DT80 while the turbine is not outputting a voltage
Voltage input to DT80 is 0-10VDC
Would like to trigger a measurement when a voltage, greater than zero, appears at the input of the DT80 (channel 1), and then stop measuring when the voltage falls to zero again.
I am using the dEX utility to program the device, and am fine with setting up the channel definition......just no sure of the triggering setup for the above
Thanks and best regards
ray