Support Forums
Power loss

I'm getting the ATTN light flicker & the following message on the DT80 when I apply the needed power. "DT80 RESTARTED - POWER LOSS".

Any help would be appreciated.
Thank you.

I'm getting the ATTN light flicker & the following message on the DT80 when I apply the needed power. "DT80 RESTARTED - POWER LOSS". Any help would be appreciated. Thank you.

Good morning Ramsey,

This is a message to let you know the power has been off to the DT80, pushing one of the front buttons will clear the message.

We have added this so if you walk up to a logger that is running you can quickly see if the dataTaker has restarted after a power loss. It also creates an entry in the event log which can be down loaded and helps with diagnosing power problems.

Cheers,
Roger

Good morning Ramsey, This is a message to let you know the power has been off to the DT80, pushing one of the front buttons will clear the message. We have added this so if you walk up to a logger that is running you can quickly see if the dataTaker has restarted after a power loss. It also creates an entry in the event log which can be down loaded and helps with diagnosing power problems. Cheers, Roger
54
1
2
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Cancel
Delete
Pending draft ... Click to resume editing
Discard draft