I try to write a script that will read the sensors on my Datataker DT85G but I run in to problems.
I try to use the command server and connect to the local ip and can see all the commands but when sending commands I get problem.

It works fine is I logg into the Datataker through the web interface. Then I can send commands and receive results. However, if I'm not logged in through the web interface I only get errors.

Is there a way providing the credentials through the command server?

Hi Josefj,

When you enable dEX security, you will not be able to send any command if the security is active. After login to dEX there is 10 minutes inactivity window before the logger automatically log you out. And when you already logged out you can't send any command from command server.

If you plan to use command interface such as DeTransfer then without supplying dEX credential you will not be able to send any command. You can access dataTaker via command interface using SIGNON command followed by username and password.

Best regards,
Rudy Gunawan

Hi
Thank you for your reply.
I managed to find SIGNON since I saw that there was a SIGNOFF command and figured out that you should be able to logon as well.
Please add SIGNON to the command list.

Best regards
Josef