Hi all,
I have what I thought was an extraordinarily simple application. I am using a DT85 to record 32 thermocouple measurements at 5 minute intervals. It is so simple I chose to make the configuration file on dEX-2 on the desktop. My problem is, when I save the configuration to the logger it scans and saves just fine but the schedule appears corrupt on dEX-2 (After channel 19, every even-numbered channel shows as blank on the tree and cannot be accessed). Furthermore, I'd like to be able to access the channels on the logger's web page to change TC type and logging interval if needed, but when I go to the logger's landing page it pops up a No configuration found. error and the schedule and channels I created in dEX-2 do not load when I choose Configure the logger. Am I missing something obvious here?
Hi all,
I have what I thought was an extraordinarily simple application. I am using a DT85 to record 32 thermocouple measurements at 5 minute intervals. It is so simple I chose to make the configuration file on dEX-2 on the desktop. My problem is, when I save the configuration to the logger it scans and saves just fine but the schedule appears corrupt on dEX-2 (After channel 19, every even-numbered channel shows as blank on the tree and cannot be accessed). Furthermore, I'd like to be able to access the channels on the logger's web page to change TC type and logging interval if needed, but when I go to the logger's landing page it pops up a No configuration found. error and the schedule and channels I created in dEX-2 do not load when I choose Configure the logger. Am I missing something obvious here?
