Hi,

I had installed a DT85 series 4, then changed the memory from 128MB to 2GB, and started up the datataker.
After starting up the LCD shifted its messages to the right of the display tell only half of the massege was shown (for example ethernet IP was 192.168.8.100 but 192.168 only appears)

I made a hard reset and "Reset" command, but after the reset the display keeps shifting again

Please Support.

Hi Beshoy,

Can you post the picture of this half displayed message?

Best regards,
Rudy Gunawan

Kindly find attached two pictures before and after shifting the message "DT85 V9.22 NO current job"

unfortunately the pictures quality is poor

Hi Beshoy,

It could be a hardware or firmware issue, please try to reinstall the firmware and see if it fix the problem. If not then you have to send it back for repair.

Best regards,
Rudy Gunawan