Good Day Everyone,
I am facing problem with applying program to logger since the power always changes from setted 'always' to 'only when taking reading' which causes our equipment to not function accordingly.

Hi ganeshraj26,

May I know what do you want to achieve with enabling analog subsystem power? Regardless the answer I will check if that was an interface issue, for temporary solution you can add a manual channel under On Logger Activation to bypass the PROFILE setting.

Best regards,
Rudy Gunawan

My apologies, it's not the analogue subsystem, it's the CEM. Does the solution still applies?

Hi ganeshraj26,

The solution is still applied, so for any PROFILE setting that can't be set through the Settings you can use a manual channel. It seems there was an interface issue in dEX 2.0.

Best regards,
Rudy Gunawan