Hello,
I hope you are well.
I have a DT85 series 4 datalogger and I want to measure the torque + rotation speed + power from my torque sensor, which has a 12 pin connector (picture attached). I have also attached the manual for the torque meter (DRBK from applied measurements). I have also attached the datalogger manual.
Any help would be greatly appreciated.
Thanks!

Hi Salman,

We apologize for the late response.
If we are not mistaken you need to use a shared ground pin for those parameters.
The first one is used for powering up the sensor:
F+E: supply +11..+28V

Then the rest for reading the data depending on the output whether voltage or current:
C+E: moment voltage output
D+E: moment voltage mass
G+E: speed
L+E: moment current output

Best regards,
dataTaker Expert