Support Forums
Alarm Value

Hi is there a way of having a mimic whereby you can input a value into a cv channel that can be used to change alarm values to avoid having to change values via the program config page as there is a number of alarms which makes it more difficult to config all in config section

Hi is there a way of having a mimic whereby you can input a value into a cv channel that can be used to change alarm values to avoid having to change values via the program config page as there is a number of alarms which makes it more difficult to config all in config section

Hi Alan,

Unfortunately, our mimic and widget in dEX are passive displays; you cannot use them as an entry point for alarms. If you still have the DeLogger 5 software (full version), it is possible to construct a responsive entry from the mimic. You can also use LabView VI or HMI units to get an external response.

Best regards,
dataTaker Expert

Hi Alan, Unfortunately, our mimic and widget in dEX are passive displays; you cannot use them as an entry point for alarms. If you still have the DeLogger 5 software (full version), it is possible to construct a responsive entry from the mimic. You can also use LabView VI or HMI units to get an external response. Best regards, dataTaker Expert
20
1
2
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft